AZDENT Curing Light Wireless LED 1 Second Curing Broad Spectrum 385-515nm 7 Modes 2500mW/cm². Use 3 Blue Light Plus 1 Purple Light High-power Chip. One Second Curing Two MM Resin. The LED Plus Model Is A 90-degree, 105-degree. Angle With 8 Watts. High power. Effective cure for most resins on the market. The magnet tail cap at the bottom of the host can be stably adsorbed on other metal surfaces
Product manual download
Installation Guide
• Insert light head into the curing light hand-piece with a twisting motion,Ensure that both the direct light source head and the light curing host are fully connected to their corresponding positions • Connect the adapter connector to the USB Type-C charging line, and then connect the power supply. The magnet tail cap at the bottom of the host can be stably adsorbed on other metal surfaces. • After switching on the power adapter, insert the charging port or pull out the charging port, the machine will wake up automatically, and the host screen will light up • The main panel indicator light "orange" indicates that the battery is in charge, and the light "green" indicates that the battery is full, and the machine will automatically stop charging. • When the host is charged for one minute in an unused state, the screen will shut down automatically, and the battery will still be charged until the battery is full。 • The battery is not fully charged prior to shipment. Please charge the battery for a minimum of 4 hours prior to first use. • To check the battery, press and hold the time switch for 4 seconds, display screen will show: a.) 4.2 – 3.7- Battery is normal b.) Lo- Battery is low • When battery is low, curing light circuit will automatically compensate for power output or turn the light off. Always recharge the curing light when the battery is low Lo • Direct charging option from transformer for easy transportation and mobility